PS2 Receiver Carrier
PS2 Receiver Carrier

E-mail this product to a friend E-mail this product to a friend

Previous  Up  Next" 

The PS2 Receiver Carrier allows you to mount a Lynxmotion PS2 receiver above other Lynxmotion electronics such as the BotBoarduino. The kit includes all the hardware needed as well as four tapping screws which replace the four existing screws on the PS2 receiver. Slots in the Lexan allow the board to be used with other electronics. Receiver not included.

Note: This is compatible with V1 and  V2 receivers (not all receivers are compatible)

Shop on Robotshop

Nylon Hex Standoffs (F / F) - 3/4
Nylon Hex Standoffs (F / F) - 3/4" x 1/4" (4-40 Tapped) (10)
SES Electronics Carrier
SES Electronics Carrier
Nylon Hex Standoffs (F / F) - 3/8
Nylon Hex Standoffs (F / F) - 3/8" x 1/4" (4-40 Tapped) (10)

The PS2 receiver includes 4x 1" M/F Hex spacers, 4x 4-40 x 3/8" screws and 4x tapping screws. Remove the existing four screws from your PS2 receiver and thread the new screws through the board and into the receiver. Note this is compatible with V1 and V2 receivers similar to the image below. The new V3 receive is not compatible.